To Connect The User Interface; Daikin Altherma - Low Temperature Split - Daikin ERLQ004CA Installer's Reference Manual

Special remark for terminals:
As mentioned on the table above, the connections on the terminals
X6M and X7M need to be changed to configure a backup heater.
Refer to the illustration below as a caution about handling the
terminals.
2 Fix the cable with cable ties to the cable tie mountings.
3 Configure the user interface for the respective power supply.
See Quick wizard: Standard.
During connection of the backup heater, miswiring is possible. To
detect possible miswiring, it is highly recommended to measure the
resistance value of the heater elements. Depending on the different
backup heater types, following resistance values (see table below)
should be measured. ALWAYS measure the resistance on the
contactor clamps K1M, K2M, and K5M.
3 kW
1~
230 V
K1M/1 K5M/13 52.9Ω
K1M/3 ∞
K1M/5 ∞
K1M/3 K1M/5 26.5Ω
K2M/1 K5M/13 ∞
K2M/3 ∞
K2M/5 ∞
K2M/3 K2M/5 52.9Ω
K1M/5 K2M/1 ∞
Example measure resistance between K1M/1 and K5M/13:
K1M
1 3 5 13
2 4 6 14
Ω
Ω
K5M
1 3 5 13
2 4 6 14
EHBH04+08 + ERLQ004~008

Daikin Altherma - Low Temperature Split

4P313774-1 – 2012.05
6 kW 6 kW 6 kW 9 kW
1~ 3~ 3N~ 3N~
230 V 230 V 400 V 400 V
52.9Ω 52.9Ω ∞ ∞
∞ ∞ 105.8Ω 105.8Ω
∞ ∞ 105.8Ω 105.8Ω
26.5Ω 26.5Ω 105.8Ω 105.8Ω
26.5Ω 26.5Ω ∞ ∞
∞ ∞ 52.9Ω 52.9Ω
∞ ∞ 52.9Ω 52.9Ω
52.9Ω 52.9Ω 52.9Ω 52.9Ω
∞ ∞ ∞ ∞
K2M K2M K2M
1 3 5 13
2 4 6 14

7.6.6 To connect the user interface

1 Connect the user interface cable to the indoor unit.
2 1
X5M
X2M
A2P A2P
a b
a User interface delivered with the unit
b Optional user interface
2 Fix the cable with cable ties to the cable tie mountings.
Fixation of the user interface to the indoor unit
1 Insert a screwdriver into the slots underneath the user interface
and carefully separate the faceplate from the wallplate.
NOTICE
The PCB is mounted in the faceplate of the user interface.
Be careful NOT to damage it.
2 Fix the wallplate of the user interface to the frontplate of the unit.
NOTICE
Be careful NOT to distort the shape of the backside of the
user interface by overtightening the mounting screws.
3 Cut off a 2 wire conductor.
4 Connect the wires to the user interface as shown below.
7 Installation
Installer reference guide
38