Advertisement
Start to use your KISS Stor SATA
Application 1: Two new disk drives.
1. Install and lock all drive carriers and they are ready for use.
2. Power on the host computer.
3. After system boot up, the RAID box will be recognized as Accusys KISS
Stor Slim by host system. And system treats it as a single disk.
4 Partition and format the RAID box before it can be used.
Note
If you have installed non-identical hard disk drives,
your computer will recognize RAID box as a single hard
disk with a capacity equal to the smaller hard disk drive
installed in the RAID box.
Application 2: Installing one disk drive with data and one new disk
drive.
1. The new disk drives must have the same capacity or larger capacity than
the drive with data.
2. Lock the disk with data at the top drive carrier and leave the new disks
unlocked at the bottom drive carriers. This identifies the disk with data as
the source drive. (The host computer must in power off state.)
3. Power on the host computer.
4. Lock the bottom drive.
5. The RAID box will immediately begin mirroring the data from the source
drive to the new disk drive in bottom drive carrier. Any old data on the
new disk drive will be lost, and is overwritten with the mirror image of the
source drive.
Contact Kontron Embedded Computers GmbH
Support: support@kontron.com
•
KISS Stor Slim 4
Advertisement
