Replacing the Traction Tires Servicing your locomotive’s lamps Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel®, TrainMaster®, Odyssey®, RailSounds™, CrewTalk™, TowerCom™, DynaChuff™, StationSounds™, Pullmor®, ElectroCoupler™, Magne-Traction®, CAB-1 Remote Controller®,...
Thereafter, it will start in forward following every three-second power interruption.) Move ‘em out! Get your locomotive moving. Press the DIRECTION button on your Lionel transformer. This sequences the Command reverse unit to the next operating state. Adjust track voltage until your locomotive moves at your desired speed. To increase speed, increase track voltage.
Transformer operations Locking your locomotive into a single operational state o select a single operational state for locomotive is now “locked” into your chosen your locomotive (example: forward direction. only), you can deactivate the Command When you no longer want single-direction reverse unit’s sequencing function with the operation, just slide the Command reverse reverse unit switch.
Lionel-compatible O gauge track. • Make sure track power is OFF before placing on the track. • Make sure your Lionel Command Base is plugged-in and its communications wire is connected to the COMMON post on your Lionel transformer or the U terminal on any of your installed PowerMasters.
TrainMaster Command operations Running your powered locomotive in the TrainMaster Command Control environment our Command-equipped powered Example Address Locomotive #1 locomotive comes factory-programmed with an ID# of “1.” To operate your powered PowerMasters set to CMD or traditional locomotive (without the non-powered power supplies ON FULL (no more than locomotive), set PowerMasters to CMD or set 20 volts)
TrainMaster Command operations CAB-1 numeric keypad commands for your locomotive Press AUX1, 0 on your CAB-1 to stop and reset the locomotive direction to FORWARD. Tuning your locomotive’s performance MOMENTUM maximum speed you want it to run, then press BOOST. Use this to keep your TrainMaster Command’s momentum feature simulates the labored performance locomotive from derailing at excessive...
TrainMaster Command operations Assigning your locomotive a new ID# our powered F-3 B-Unit locomotive has Assign a new ID# to your Example been factory-programmed as ID# 1. Command-equipped locomotive To change the individual ID#, switch the Set the Command reverse unit switch...
1. On your CAB-1 Remote Controller, press TR, then enter your lash-up ID# (1-9). 2. Enter the powered F-3 B-unit’s unique ID#, then press R to activate the back-up light. If you choose to add an additional unit to create an A-B-A lash-up and want to de- Note! activate the back-up light, do not press R.
Maintaining and servicing your locomotive Lubricating your locomotive avoid getting grease or oil on the locomotive’s elp your Lionel locomotive lead a long and productive life on your railroad by wheels or your track. You’ll know your maintaining it properly.
Center or Lionel Service. (For more replacement. information, see Lionel Service on page 12.) Start by separating the plastic body shell Insert the replacement lamp’s prongs into from the frame. Remove the screw from each the socket, making sure of a tight connection.
Center, together with proof of original purchase above instructions carefully before returning any will, at the option of Lionel L.L.C., be repaired or merchandise for service. You may choose to have replaced, without charge for parts or labor. In the...