Configuration Screens - Yamaha RACK Reference Manual

Configuration screens

INPUT screen
Allows you to change the stereo link setting, select an input source, turn phantom power on
and off, turn phasing on and off, and adjust input gain.
1
Stereo link selection button
Allows you to select whether two adjacent mono input channels are linked as a stereo
pair, or behave as two separate mono channels. Touch to display the popup menu.
OFF: Stereo link is disabled.
CH1&2: Stereo link is enabled. When stereo link is enabled, the odd numbered channel
is the left side of the stereo pair, and the even numbered one is the right. The
channel numbers displayed in the popup menu depend on the channel whose
settings you are editing.
CH2&3: Stereo link is enabled. When stereo link is enabled, the even numbered channel
is the left side of the stereo pair, and the odd numbered one is the right. The
channel numbers displayed in the popup menu depend on the channel whose
settings you are editing.
2
Input selection buttons
Allows you to select the channel's input source. The available sources depend on the
channel whose settings you are editing.
INPUT: The device connected to the INPUT jack will be used as the input source.
USB: The computer connected to the USB TO HOST connector will be used as the input
source.
SLOT (V2.0 and later): Allows you to select an input from the NY64-D installed in the
Playback: Displayed for ST IN1. Allows you to select a USB storage device that is connected
to the USB connector on the top panel as an input.
NOTE
When USB is selected, the gain slider (
When SLOT is selected, analog gain adjustment and the +48V button cannot be used if the HA Control
button on the SLOT SETUP screen is not turned on. Additionally, for inputs from a device whose head
amp cannot be controlled, the gain slider (
8
( ) is not displayed.
Even if you select SLOT as the input source, if a source is not actually available (such as
when there is no NY64-D installed, no Tio1608-D or stage box connected, no Dante
patching, etc.), this "virtual HA" state is displayed in the HA box area of this screen, the
OVERVIEW screen, and the CH VIEW screen.
3
GainFinder
Displays the input's gain adjusted level. When adjusting the input gain, adjust it so that
the center of the GainFinder lights up. When the input source is set to INPUT, the
GainFinder displays the digital input's gain.
- 46 -
Configuration screens
expansion slot. Use this button when selecting an input from a
Tio1608-D or stage box connected to the NY64-D and the
Dante network. See page 91 for information about SLOT port
numbers and channels.
7
) adjusts digital gain, and the +48V button (
7
) becomes a digital gain adjustment, and the +48V button
8
) is not displayed.
TF Series
Reference Manual