Assigning Channels To A Dca Group - Yamaha RACK Reference Manual

Assigning channels to a DCA group

1. Press the [INPUT1] and [INPUT2] buttons on the top panel simultaneously to display
the GROUP channels.
2. Press a [SEL] button on the top panel that corresponds to the DCA group that you
want to configure.
3. Touch the DCA buttons that correspond to the channels you want to assign to the
group. (You can select multiple channels.)
The selected channels are displayed in the channel display area.
Channel is selected
DCA ASSIGN screen menu
Press the Menu key ( ) from the DCA ASSIGN screen to display the following options.
1
Clear All
Removes all channels from the group.
DCA roll out
You can assign DCA groups 1–8 to the last 8 channel strips on the right side of the console's
top panel.
(TF5: channel strips 25–32; TF3: 17–24; TF1: 9–16)
You can then assign the channels of a DCA group to the channel strips on the left side of the
console's top panel by pressing the corresponding DCA group's [SEL] key.
(TF5: channel strips 1–24; TF3: 1–16; TF1: 1–8)
The number of channels in the group that will be assigned to the channels strips depends on
the model number. For the TF5 console, the 24 lowest numbered channels in the group are
assigned; the lowest 16 for the TF 3, and the lowest 8 for the TF1.
This feature allows you to manipulate the channels strips for both the DCA group master and
the group's "member" channels at the same time.
Member channels of selected DCA group
assigned to these channel strips
NOTE
For TF-RACK, this item is displayed only in the OVERVIEW screen. The channels assigned to the faders
are the same as for the TF1.
- 76 -
Configuration screens
DCA groups 1–8
assigned to these
channel strips
TF Series
Reference Manual