Changes And Additions Of Screens; New Fader View Screen; Clock On The Meter Bridge; Displaying The Geq Routings - Yamaha PM1D Supplementary Manual

Changes and additions of screens

New FADER VIEW screen

The FADER VIEW screen has been added to the IN CH View
function and OUT CH View function.
FADER VIEW
1
2
3
1
2
3
1 ON/MUTE
These buttons enable you to switch the channels on/off,
and switch DCA group muting on/off. They are linked to
the [ON] switches of the corresponding channels and the
[MUTE] switches of the DCA groups.
2 Level
These buttons enable you to adjust the level of the channels
and DCA groups. The current value is shown in the box
immediately below. They are linked to the encoder or fader
of the corresponding channel or DCA group.
3 CUE
These buttons enable you to switch cue monitoring on/off
for the channels and DCA groups. They are linked with the
[CUE] key of the corresponding channel or DCA group.
4 DISPLAY CH
Switches the channels that are shown in the FADER VIEW
screen.
• When you are using the IN CH View function:
Channels specified via the Panel
Assign function, and DCA groups
INPUT [PANEL]
1–12
Input channels 1–48, ST IN chan-
CH 1-48/ST IN 1-4
nels 1–4, DCA group 1–12
Input channels 49–96, ST IN
CH 49-96/ST IN 5-8
channel 5–8, DCA groups 1–12
• When you are using the OUT CH View function:
MIX channels 1–48, STEREO A/
MIX 1-48
B channels, DCA groups 1–12
MATRIX channels 1–24, STE-
REO A/B channels, DCA groups
MATRIX
1–12
8
Changes and additions of screens

Clock on the meter bridge

The TIME CODE indicator on the meter bridge block can now
display the current time. Also, an additional parameter enables
you to switch between the current time and time code.
PREFERENCE
4
TIME CODE DISPLAY
PRESENT TIME
TIME CODE

Displaying the GEQ routings

When you select a GEQ module in the GEQ PARAMETER
screen, the GEQ SELECT pop-up window enables you to iden-
tify any GEQ modules that have already been patched.
This window displays the signal routing of already-patched
GEQ modules, and displays "NO ASSIGN" for unpatched
GEQ modules.
TIME CODE DISPLAY section
Displays the current time in 24-hour for-
mat (hours/minutes/seconds).
Displays the time code.