Release Material Installation (Optional) - Garland MWEFH-9501 Operation Manual

NOTE: TEFLON ROLLUP BAR ASSEMBLY'S ARE SEPARATE FOR LEFT AND FOR RIGHT.
NOTE THE "L" OR "R" STAMPED ON THE BRACKET ASSEMBLY FOR CORRECT
WARNING: UPPER PLATEN TEMPERATURES ARE VERY HOT. PLATEN SHOULD BE
1. If attached, remove Teflon sheet clips located on the
front of the platen.
2. Insure Teflon bar that is bolted to the upper platen
is free and clear of carbon buildup, and clean as
necessary.
3. Install Teflon rollup bar bracket by placing new rollup
over existing Teflon bar, with the set screws facing
DOWN (See Figure 1).
4. Tighten set screws using 1/8" allen wrench.
5. Install teflon roller bar in rollup bracket. (See Figure
2)

RELEASE MATERIAL INSTALLATION (OPTIONAL)

POSITIONING.
COOL WHILE INSTALLING
Figure 1 - Teflon Rollup bar bracket
Figure 2 - Inserting teflon roller bar into bracket
14
Insert this end first