Best IDH Max 1300 Installation Instructions Manual page 9

Installing the lock
9
Install mortise case
1 Remove the faceplate from the mortise case.
2 Insert the mortise case into the mortise cavity, while
feeding the sensor and solenoid wires into the mortise
cavity and out the sensor & solenoid wire hole to the
inside of the door.
Note: The field wire harness should be routed above and
behind the mortise case (depending on where the hole
through the door meets the mortise cavity).
3 Make sure there are 3" to 4" of slack in the field wire
harness to allow access to the control electronics cir-
cuit board in the inside trim.
4 Secure the mortise case with the case mounting
screws.
10
Install mounting plates
1 Insert the outside mounting plate through the door
and mortise case.
2 Position the inside mounting plate opposite the out-
side mounting plate and screw them securely in place.
Caution: Do not overtighten the mounting plate
screws. Overtightening may compress the mortise
cavity and bind the locking mechanism.
Installation Instructions for IDH Max 1300 Mortise Locks Installation Instructions for IDH Max 1300 Mortise Locks
Mortise cavity
Field wire harness
Sensor & solenoid
wire hole and wires
Figure 9
Outside
mounting plate
Figure 10 Installing the mounting plates
BEST ACCESS SYSTEMS
A Division of Stanley Security Solutions, Inc
Inside of door
Mortise
case
Installing the mortise case
Outside of door
Inside
trim
Inside
mounting
plate
9