Advertisement
Completing the installation at the door
15
Secure through-bolt trim and complete
connections
1 Position the inside and outside trim onto the door.
2 Making sure that the trim does not pinch the
wires, secure the trim to the door—but do not
tighten. Use the combination mounting screw at the
top trim hole and the standard mounting screw at the
bottom trim hole.
Caution: When routing the solenoid and sensor
wire harness, the sensor wires, and the solenoid
wires, make sure the wires are not routed across
any sharp edges or over any surface that could
damage their sleeving or wire insulation.
3 Make the solenoid connection and three sensor con-
nections, and place the wires into the inside trim.
Wire connection
Solenoid
RQE
Latch status sensor
Door status sensor
Caution: When making the sensor connections
and solenoid connection, make sure:
■
there are no loose wire connections where the
wires are inserted into the connectors
the connectors are firmly mated.
■
16
Install inside and outside knobs/levers
For both knobs and levers
Unscrew the inside spindle one (1) full turn to allow the
spindles to turn freely.
For knobs
1 From the outside of the door, insert the outside knob
and spindles assembly into the lockset.
No.
No.
Color
of
of
wires
pins
Yellow
2
3
Brown/
2
3
Orange
Purple
2
2
White
2
2
BEST ACCESS SYSTEMS
A Division of Stanley Security Solutions, Inc
Installation Instructions for IDH Max 1300 Mortise Locks
Installation Instructions for IDH Max 1300 Mortise Locks
Inside of door
Figure 15 Securing the through-bolt trim and
completing connections
Outside of door
Figure 16a Installing the knobs
Inside trim
Combination
mounting screw
Make these
connections.
Standard
mounting screw
Set screw
cap
Set screw
Spindles
Inside of door
15
Hide quick links:
Advertisement
