Advertisement
Installation Instructions for IDH Max 1300 Mortise Locks
Caution 1: When routing the reader wire harness,
make sure the reader wire harness is not routed
across any sharp edges or over any surface that could
damage its sleeving or wire insulation.
Caution 2: When connecting the reader wire harness,
make sure:
there are no loose wire connections where the wires
■
are inserted into the reader wire connector
the reader wire harness connector is fully seated in
■
its mating connector on the control electronics cir-
cuit board.
Reader wire harness
connector
Control electronics
circuit board
Solenoid and sensor
wire harness
Inside trim
Large opening
Sensor wires and
solenoid wires
Figure 13b Connecting the reader wire harness to the
control electronics circuit board
12
Installing the lock
13
1 From the outside of the door, feed the reader wire har-
2 Temporarily rest the outside trim on the door by
3 Connect the reader wire harness to the control elec-
4 Feed the solenoid and sensor wire harness from the
Inside of door
Figure 13a Feeding the reader wire harness connector
BEST ACCESS SYSTEMS
A Division of Stanley Security Solutions, Inc
Connect reader wire harness
ness connector through the field harness & reader wire
hole.
inserting the trim studs into the stud holes.
Note: You can temporarily install the outside knob/lever
to hold the outside trim in place. See Task 15.
tronics circuit board in the inside trim.
control electronics circuit board, as well as the sole-
noid and sensor wires from the mortise case, through
the large opening in the inside trim.
Outside of door
from the outside trim through the door
Reader wire
harness connector
Field harness &
reader wire hole
Outside trim
Hide quick links:
Advertisement
