Advertisement
Completing the installation at the door
18
Install access door
1 Making sure that the access door does not pinch
any wires, insert the tabs of the access door into its
mating slots and swing the door closed.
2 Use a T15 TORX bit driver to secure the access door
with the security screw. Tighten firmly.
19
Install wire transfer hinge
1 Trim the four wires of the field wire harness, which you
pulled through the hinge edge of the door in Task 8.
Leave sufficient length to connect to the wire transfer
hinge.
2 Splice the power and communication field wiring to
the four pairs of leads on the frame side of the hinge,
following the hinge manufacturer's instructions.
3 Splice the four field wire harness wires (listed in the
table below) to the four pairs of leads on the door side
of the hinge, matching each pair of leads to its corre-
sponding field wire.
Wire
Color
Ground Black
12 VDC Red
Com+
Orange
Com–
Green
4 Insert the wires and splice connectors into the holes or
pockets in the door and frame, being careful not to
pinch the wires. Install the wire transfer hinge.
Installation Instructions for IDH Max 1300 Mortise Locks
Installation Instructions for IDH Max 1300 Mortise Locks
Figure 18 Installing the access door
Access holes
Field wires
Splice
connectors
Wire transfer
hinge
Door frame
Figure 19 Installing the wire transfer hinge
BEST ACCESS SYSTEMS
A Division of Stanley Security Solutions, Inc
Security screw
Tabs
Field wire
harness leads
Door
17
Hide quick links:
Advertisement
