Installation Instructions for IDH Max 1300 Mortise Locks
Sensor &
solenoid
wire hole
Inside of RH door
Outside of RHRB door
Figure 4a Drilling the RH and RHRB holes
Cylinder
hole
Outside of LHRB door
Figure 4b Drilling the LH and LHRB holes
6
Upper trim hole
Field harness &
reader wire hole
Cylinder hole
Through-bolt
holes
Knob/lever hole
Lower trim hole
Upper trim hole
Field harness &
reader wire hole
Through-bolt
holes
Knob/lever hole
Lower trim hole
Sensor & solenoid
wire hole
Inside of LH door
BEST ACCESS SYSTEMS
A Division of Stanley Security Solutions, Inc
Preparing the door and door jamb
4
Drill holes
Caution: Check for the correct lock function, hand,
and bevel before drilling.
Drill the holes listed below:
upper and lower trim holes
■
5/8" diameter
▲
through door
▲
field harness & reader wire hole
■
7/8"diameter
▲
through door
▲
location based on handing
▲
■
cylinder hole
▲
1 1/4"diameter
▲
from outside into mortise cavity
EEL and EEU functions only
▲
upper and lower through-bolt holes
■
3/8" diameter
▲
through door
▲
knob/lever hole
■
7/8" diameter
▲
through door
▲
sensor & solenoid wire hole
■
7/8" diameter
▲
from inside into mortise cavity, approximately 1"
▲
deep
Note 1: To locate the center of a hole on the opposite
side of the door, drill a pilot hole completely through the
door.
Note 2: For holes through the door, it is best to drill half-
way from each side of the door to prevent the door from
splintering.