Installation; Beam Spread - Bosch ISC-FPB1-W60QS Installation And Operation Manual

Photobeam 5000
Table of Contents

Advertisement

Photobeam 5000
3

Installation

Prior to installing the devices, please review the installation considerations below:
3.1

Beam spread

The beam spread angle is ±0.7 °from the transmitter to the receiver. Refer to the diagram and
table below to determine the installation conditions.
1
Figure 3.1: Beam distance and spread
Callout ﹘ Description
1 ー Transmitter
2 ー Horizontal spread (B)
3 ー Vertical spread (C)
Bosch Security Systems, Inc.
Install in an area that is clear of objects
Install the transmitter/receiver within the maximum protection range of the model
Do not install:
Receivers into intense sources of light (for example, rising and setting sun)
On movable surfaces subject to vibrations
Detectors where immersion to water, corrosive liquids, or exposure to high levels of
dust can occur
Detectors in close proximity to strong electromagnetic noises
Do not use detectors with other photobeam detectors or receivers
Do not stack detectors
Do not disassemble or modify this detector
Do not install while the power is on
Avoid extreme temperature and humidity ranges as defined in the products specifications
Avoid installing detectors near magnets and/or magnetized materials
Avoid beam interference between other units when multiple units are installed.
Installation and Operation Guide
5
Callout ﹘ Description
4 ー Receiver
5 ー Distance (A)
Installation | en
9
2
3
4
2016.02 | 03 | F.01U.305.910

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ISC-FPB1-W60QS and is the answer not in the manual?

This manual is also suitable for:

Isc-fpb1-w120qsIsc-fpb1-w200qs

Table of Contents