Photobeam 5000
1
Figure 3.3: Attaching the mounting bracket
Callout ﹘ Description
1 ー Mounting hardware
2 ー Mounting plate
3 ー Clamping screws (short)
Attaching the mounting plate:
1.
2.
1
Figure 3.4: Attaching the U-clamp
Callout ﹘ Description
1 ー U-clamp
2 ー Mounting pole
3 ー Mounting plate
4 ー Clamping screws (long)
Wire routing:
1.
2.
3.
4.
5.
Bosch Security Systems, Inc.
2
Attach the mounting plate to the poles using the U-clamps.
Use the U-clamps and clamping screws to attach the mounting plate firmly to the poles.
2
3
Route the wire through the wire entry location of the mounting plate, leave enough wire
to reach the terminal strip.
Route the wire through the transmitter's wire entry.
Slide the transmitter onto the mounting plate, and secure using the included screws.
Repeat this procedure for the receiver, verify line-of-sight with the transmitter.
Wire to the terminal strips. Refer to Wiring, page 13 for wiring procedures.
Installation and Operation Guide
3
4
Installation | en
11
2016.02 | 03 | F.01U.305.910