Cowl And Spinner Installation - AeroWorks EXTRA 260 FREESTYLE QB-L User Manual

COWL/SPINNER
INSTALLATION
1. Gather the items listed below for the installation
of the cowling and spinner.
Required Parts
◊
1 - Cowling
◊
4 - 4-40 Mounting bolts
◊
1 - Aeroworks plastic spinner w/mounting
hardware
Required Parts-Not Included
◊
1 - Propeller- Specific size will depend on
motor selection
Required Tools and Adhesives
◊
5/64" Ball driver
◊
Small Phillips screw Driver
2. Slide cowling over motor and onto fuse as
shown.
52" Aeroworks Extra 260 Freestyle Assembly Manual
3. Install (4) 4-40 mounting bolts into pre-installed
blind nuts as shown.
4. Locate the supplied spinner and mounting hard-
ware.
5. Test fit spinner back plate onto prop hub, if a
spacer is needed find the correct size spacer and
install in the back of the spinner.
6. Install the correct spacer in the prop as shown.
Note: Failure to install the correct spacer can result
in damage to your model or personal injury.
23