Fujitsu LPF-D711W User Manual page 57

4
Loosen two screws on the lamp unit to pull out it.
The lamp unit is so constructed that the screws cannot be detached from it.
5
Reverse the disassembling procedure above to set
the lamp unit and lamp unit cover in position.
Check that the lamp unit is installed securely.
6
After inserting the power plug into the receptacle,
press "ENTER" button, and then, press "POWER"
button five times.
At this time, all monitor indicator lamps blink for a few seconds.
The lamp timer is initialized to "0".
* When replacing the lamp unit, do not touch the glass inside the projector.
Dust and fingerprints sticking to the glass may deteriorate the luminous
intensity of the light source lamp and shorten its life.
Note
• For replacement, be sure to use a lamp unit specified by the manufacturer only. Otherwise, failure of the lamp to light up, and explosion or damage
of the lamp will result.
• Turn on the light source lamp, and press
Downloaded From projector-manual.com Fujitsu Manuals
to select the lamp timer. Check that "0" is set for the lamp timer. Otherwise, initialize the timer again.
Loosen two screws.
Replace lamp unit with a new one.
E-57