Fujitsu LPF-D711W User Manual page 51

• Setting RGB Input Signal Compulsorily (Direct Setting)
You can use this option to switch the setting for RGB input signal.
Each time you press
[Auto]: The optimum display is obtained automatically for input signals.
[Others]: The optimum resolution setting is fixed for each signal.
Press to store.
* In Auto mode, the resolution of VGA, WVGA, 480P, XGA, WXGA, SXGA and SXGA
automatically distinguished. Switch to the fixed display when the image is not displayed properly.
* Signals that are not applicable depending on the model or input terminals may not be displayed.
• Specifying RGB Input Signal (Code Setting)
Normally, use this option in Auto mode.
• Changing background color to blue (Blank Screen)
When no picture signal is input, the background color can be changed to blue.
Each time
Black
Press to store.
• Setting Exhibition Mode (Exhibition Mode)
You can use this option to display the enhanced contrast, to demonstrate the projector's bright, high
contrast picture.
Each time you press
On Off
Press to store.
* In Exhibition mode, the display returns to the original setting in about 5 minutes even if the adjustment is changed.
* The setup will be cancelled when removing the power plug from the receptacle.
Note
• The screen display disappears if there is no operation within approximately 60 seconds.
• Depending on the model or the optional devices, some of the functions may not be available.
• The adjustment range varies according to the display signals. Make adjustments to your preferred Sharpness within the adjustment range.
• Depending on the type of signal, it may not be possible to make some of the settings or adjustments.
Downloaded From projector-manual.com Fujitsu Manuals
or , one of the available choices appears in the following sequence:
or is pressed, the background color changes over.
Blue
or , one of the available choices appears in the following sequence:
for RGB
+
may not be
for mD-sub input
E-51