Table of Contents
Advertisement
CHAPTER 4: Troubleshooting
4.5 No resistance or incorrect resistance (continued)
B) If the ECB motor can move, the resistance can be adjusted. If the resistance is too strong,
check the flywheel to make sure that the gap between the orange block and the bottom is within 1-2
mm.
If the gap is bigger than 1-2 mm, the resistance will be stronger than normal. Adjust the cable to the correct gap
range.
3.
If steps 1 & 2 do not fix the issue, the inside magnet is defective. Replace the inside magnet.
21
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
