Sharp UP-5350 Installation Manual page 9

How to Extend Display Pole
The pole can be extended by installing the attached pole to the
standard pole.
COMPONENT LIST:
No. NAME
, Pole cabinet Pole extension
Screw (M3 4) Pole connection
Securing the UP-P20DP to
Screw (M4 16)
the wooden table
Securing the UP-P20DP to
Screw (M4 20)
the metal table
Securing the UP-P20DP to
Nut
the metal table
Display cable (S) This display cable (S)
should be used instead of
the standard cable and
earth wire if the UP-20DP's
Earth wire (S)
standard pole is removed
to lower the height of the
UP-20DP.
1) Remove the five screws .
2) Remove the Base angle .
3) Remove the PWB unit from the Base cabinet
4) Remove the display cable
Pattern side(PWB)
Core
2
1
1
USE Q'ty
2
4
4
4
4
1
1
.
from the PWB unit .
4
3
5
5) Remove the two screws .
6) Remove the Base cabinet
4
6
7) Pull the Ratchet attached to the pole cabinet
Display unit by turning it as shown in Figure A.
8) Remove the two screws .
9) Remove the pole cabinet from the Ratchet
8
10
10
7
from the pole cabinet .
7
out of the
.
9
9