Rear Display Up-I20Dp; Pole Display: Up-P20Dp - Sharp UP-5350 Installation Manual

Align threaded holes completely before securing the I/F PWB with
screws.

15. Rear display UP-I20DP

1) Remove the Display filter
2) Remove the Rear cover angle
a) Remove the two Screws
1
1
from the Display filter
2
3
3) Connect the display cable
PWB
4) Install the Display unit to the cabinet
a) Align the positioning boss
angle hole in the display unit.
A
A

16. Pole display: UP-P20DP

1) Install the core to the display cable
cable .
2) Connect the Display cable
the back of the set.
3) Fix the display cable with the cable holder
screw on the back of bottom cabinet.
4) Fix the display earth cable
.
Cable holder
Use the following type of cable holder supplied with the UP-
P20DP.
"3N" (large type)
to the connector: CN: 1 on the Main
of the bottom cabinet with the
4
5
A
and the display earth
to the remote display connector on
, and tighten the
to the main chassis with the screw