Battery Pack; Assembly; Guard - Yardworks 60-2241-0 Owner's Manual

Battery Pack (Fig. E)
IMPORTANT!
The battery is not shipped fully charged.
It is recommended that the battery be fully charged before
the initial use.
With regular use, the battery pack will take 60 MINUTES or
less to charge fully. It is recommended that the battery be
charged every 3 months when the trimmer is not in use.
The battery's run time will improve after the third or fourth
charge.
Use YARDWORKS 60-2143-4 replacement
battery.
To Remove
1. Press the latch buttons (1) in and hold them.
2. Grasp the trigger handle (2) firmly. Pull the battery pack
out of the handle.
NOTE: The battery pack fits snugly into the handle in order
to prevent accidental dislodging. Removal may require the
use of a certain amount of force.
To Install
1. Align the tongue (3) of the battery pack with the cavity in
the handle housing.
2. Grasp the trigger handle (2) firmly.
3. Push the battery pack into the handle until both sides
lock. The latch buttons will click when they lock.
4, Do not use force when inserting the battery pack. It
should slide into place and click.

Assembly

Guard (Fig. F)
WARNING
To avoid injury, always remove the battery pack before installing
the guard or the cutting line, or making any adjustments. If the
guard is damaged, do not use the grass trimmer until it is
replaced.
NOTE: Install the protective guard before using the grass trimmer.
Once it is installed, it cannot be removed or disassembled.
1. Remove the battery pack.
2. Turn the grass trimmer upside-down in order to access the
trimmer head.
3. Unscrew the guard assembly screw (1) from the base of the
trimmer head. The screw has been pre-installed on the motor
head for shipping.
4. Fit the guard tabs (2) into the grooves on the trimmer head so
that the guard sits level on the rim of the trimmer head (3).
5. Turn the guard clockwise as far as possible, until it is securely
in place. If the guard does not turn easily, readjust the position.
6. When the larger side of the guard is facing the same direction
as the handle, the screw hole (4) will be aligned with the hole
(5) in the rim of the trimmer head.
7. Insert the screw (1) into the guard and the trimmer head, and
then tighten it securely.
WARNING
To avoid injury and to reduce the risk of electric shock or
fire:
• Replace the battery pack or the charger immediately if the
battery case or the charger cord is damaged.
• Always verify that the grass trimmer switch is in the OFF
position before inserting or removing the battery pack.
• Always verify that the battery pack is removed and that the
switch is in the OFF position before replacing the spools or
adjusting the line.
• Read, understand, and follow the instructions for using the
Battery Charger.
4
5
8
2
3
1
Fig. E
Fig. F
2
3
1