Matrix mvBlueFOX3 Technical Manual page 1818

LUTEnable
LUTIndex
LUTValue
LUTValueAll
mvLUTType
mvLUTInputData -
mvLUTMapping
Feature Name
TestControl
TestPendingAck
TestEventGenerate@i -
1810
0,
- - -
1
0 255 1 -
0 1023 1 -
- - - -
Direct,
- - -
Interpolated
Bayer,
- -
RGB
map_8To12,
- - -
map_10To10
Min Max
0 INT_MAX 1
-
21 Appendix A.2 CMOS specific camera / sensor data
Luminance: Selects the Luminance LUT.
Activates the selected LUT.
Control the index (offset) of the coefficient
to access in the selected LUT.
Returns the Value at entry LUTIndex of
the LUT selected by LUTSelector.
Accesses all the LUT coefficients in a
single access without using individual
LUTIndex.
Describes the type of LUT used.
Direct: The user can define an output
value for each input value of the LUT.
Interpolated: The user can define the
output values for equidistant nodes in the
LUT. Linear interpolation is used to
determine the output values for input
values that lie in between the given nodes.
Describes the data the LUT is operating
on
Bayer: The LUT is operating on raw Bayer
data (i.e. before debayering)
RGB: The LUT is operating on RGB data
(i.e. after debayering)
Describes the mapping of the LUT
map_8To12: The LUT maps 8 bit input
data to 12 bit output data.
map_10To10: The LUT maps 10 bit input
data to 10 bit output data.
Valid
Inc
Values
A category for Test Control features.
Tests the device's pending
acknowledge feature. When this
feature is written, the device waits a
-
time period corresponding to the
value of TestPendingAck before
acknowledging the write. (ms)
- - Generates a Test Event.
Documentation