Matrix mvBlueFOX3 Technical Manual page 1946

CounterDuration
CounterValue
CounterValueAtReset
CounterReset@i
TimerSelector
1938
21 Appendix A.2 CMOS specific camera / sensor data
0 UINT_MAX 1
0 UINT_MAX 1
0 UINT_MAX 1
- -
- -
-
-
-
- -
- Timer1,
Timer2
trigger signal.
FallingEdge: Starts
counting on the Falling
Edge of the selected
trigger signal.
AnyEdge: Starts counting
on the Falling or rising
Edge of the selected
trigger signal.
LevelHigh: Counts as
long as the selected
trigger signal level is
High.
LevelLow: Counts as
long as the selected
trigger signal level is
Low.
Sets the duration (or
number of events) before
the CounterEnd event is
generated.
Reads or writes the
current value of the
selected Counter.
Reads the value of the
selected Counter when it
was reset by a trigger or
by an explicit
CounterReset command.
Does a software reset of
the selected Counter and
starts it. The counter
starts counting events
immediately after the
reset unless a Counter
trigger is active.
CounterReset can be
used to reset the Counter
independently from the
CounterResetSource. To
disable the counter
temporarily, set
CounterEventSource to
Off.
Selects which Timer to
configure.
Timer1: Selects the
Timer 1.
Timer2: Selects the