Matrix mvBlueFOX3 Technical Manual page 1346

UserSetLoad@i
UserSetSave@i
UserSetDefault
UserSetDefaultSelector -
Feature Name
EventControl
EventSelector
EventNotification
1338
- - -
- - -
- - -
- -
Min Max Inc Valid Values
ExposureEnd,
Line4RisingEdge,
- - -
Line5RisingEdge,
FrameEnd
- - -
21 Appendix A.2 CMOS specific camera / sensor data
UserSet3, set.
UserSet4 UserSet1: Selects the user set 1.
UserSet2: Selects the user set 2.
UserSet3: Selects the user set 3.
UserSet4: Selects the user set 4.
Loads the User Set specified by
- UserSetSelector to the device and
makes it active.
Save the User Set specified by
- UserSetSelector to the non-volatile
memory of the device.
Selects the feature User Set to load
and make active by default when the
Default, device is reset.
UserSet1, Default: Select the factory setting user
UserSet2, set.
UserSet3, UserSet1: Select the user set 1.
UserSet4 UserSet2: Select the user set 2.
UserSet3: Select the user set 3.
UserSet4: Select the user set 4.
This feature is deprecated (See
UserSetDefault). Selects the feature
User Set to load and make active when
Default,
the device is reset.
UserSet1,
Default: Select the factory setting user
UserSet2,
set.
UserSet3,
UserSet1: Select the user set 1.
UserSet4
UserSet2: Select the user set 2.
UserSet3: Select the user set 3.
UserSet4: Select the user set 4.
A category that contains Event
control features.
Selects which Event to signal to the
host application.
ExposureEnd: Device just
completed the exposure of one
Frame (or Line).
Line4RisingEdge: The event will be
generated when a Rising Edge is
detected on the Line 4.
Line5RisingEdge: The event will be
generated when a Rising Edge is
detected on the Line 5.
FrameEnd: Device just completed
the capture of one Frame.
Documentation