Matrix mvBlueFOX3 Technical Manual page 1421

21 Appendix A.2 CMOS specific camera / sensor data
TimerTriggerActivation
TimerDuration
TimerDelay
TimerValue
- - -
0.000 UINT_MAX -
0.000 UINT_MAX -
0.000 UINT_MAX -
RisingEdge,
FallingEdge,
AnyEdge,
LevelHigh,
LevelLow
-
-
-
trigger to start the Timer.
UserOutput0: Specifies
which User Output bit
signal to use as internal
source for the trigger.
UserOutput1: Specifies
which User Output bit
signal to use as internal
source for the trigger.
UserOutput2: Specifies
which User Output bit
signal to use as internal
source for the trigger.
UserOutput3: Specifies
which User Output bit
signal to use as internal
source for the trigger.
Selects the activation
mode of the trigger to
start the Timer.
RisingEdge: Starts
counting on the Rising
Edge of the selected
trigger signal.
FallingEdge: Starts
counting on the Falling
Edge of the selected
trigger signal.
AnyEdge: Starts counting
on the Falling or Rising
Edge of the selected
trigger signal.
LevelHigh: Counts as
long as the selected
trigger signal level is
High.
LevelLow: Counts as
long as the selected
trigger signal level is
Low.
Sets the duration (in
microseconds) of the
Timer pulse. (us)
Sets the duration (in
microseconds) of the
delay to apply at the
reception of a trigger
before starting the Timer.
(us)
1413