Matrix mvBlueFOX3 Technical Manual page 1625

21 Appendix A.2 CMOS specific camera / sensor data
mvLUTMapping
Feature Name
TestControl
TestPendingAck
TestEventGenerate@i -
Feature Name
TransportLayerControl
PayloadSize
mvU3VPHYErrorCount 0
mvU3VLNKErrorCount 0
Feature Name
UserSetControl
UserSetSelector
- - - map_10To12
Min Max
0 INT_MAX 1
-
Min
INT_MIN INT_MAX
INT64_MAX 1
INT64_MAX 1
Min Max Inc
- - -
Describes the data the LUT is operating
on
Gray: The LUT is operating on gray data
Describes the mapping of the LUT
map_10To12: The LUT maps 10 bit input
data to 12 bit output data.
Valid
Inc
Values
A category for Test Control features.
Tests the device's pending
acknowledge feature. When this
feature is written, the device waits a
-
time period corresponding to the
value of TestPendingAck before
acknowledging the write. (ms)
- - Generates a Test Event.
Valid
Max Inc
Values
1 -
-
-
Valid
Values
A category that contains the User Set
control features.
Default, Selects the feature User Set to load,
UserSet1, save or configure.
UserSet2, Default: Selects the factory setting user
UserSet3, set.
UserSet4 UserSet1: Selects the user set 1.
Documentation
Documentation
Category that contains the
transport Layer control
features.
Provides the number of
bytes transferred for each
image or chunk on the
stream channel. This
includes any end-of-line,
end-of-frame statistics or
other stamp data. This is the
total size of data payload for
a data block.
Counts the number of errors
on the PHY interface.
Counts the number of errors
on the USB3 link.
Documentation
1617