Matrix mvBlueFOX3 Technical Manual page 932

CounterReset@i
TimerSelector
TimerTriggerSource
924
20 Appendix A.1 Pregius CMOS specific camera / sensor data
- -
- -
- -
- -
Timer1,
-
Timer2
- Off,
AcquisitionStart,
AcquisitionEnd,
FrameStart,
FrameEnd,
ExposureStart,
ExposureEnd,
Line4,
Line5,
Counter1End,
Counter2End,
Counter3End,
Counter4End,
Timer1End,
Timer2End,
mvLogicGateOR1Output,
mvLogicGateOR2Output,
mvLogicGateOR3Output,
mvLogicGateOR4Output,
UserOutput0,
UserOutput1,
UserOutput2,
UserOutput3
CounterReset command.
Does a software reset of
the selected Counter and
starts it. The counter
starts counting events
immediately after the
reset unless a Counter
trigger is active.
CounterReset can be
used to reset the Counter
independently from the
CounterResetSource. To
disable the counter
temporarily, set
CounterEventSource to
Off.
Selects which Timer to
configure.
Timer1: Selects the
Timer 1.
Timer2: Selects the
Timer 2.
Selects the source of the
trigger to start the Timer.
Off: Disables the Timer
trigger.
AcquisitionStart: Starts
with the reception of the
Acquisition Start.
AcquisitionEnd: Starts
with the reception of the
Acquisition End.
FrameStart: Starts with
the reception of the
Frame Start.
FrameEnd: Starts with
the reception of the
Frame End.
ExposureStart: Starts
with the reception of the
Exposure Start.
ExposureEnd: Starts with
the reception of the
Exposure End.
Line4: Starts when the
specified
TimerTriggerActivation
condition is met on the
chosen I/O Line.
Line5: Starts when the