Calc’nclean; Tips On Energy Saving - Siemens CT636LE SERIES Instruction Manual

■ Remove the container, empty the drip
trays, replace and close the appliance
door
■ Press C The appliance has
finished cleaning and is ready for use
again
■ Press E to exit the program
calc'nClean
Takes about 26 minutes
calc'nClean combines the functions Descale
and Clean If both programmes are due
to be carried out close together, the fully
automatic coffee machine will automatically
suggest this service programme
■ Press button E
■ Turn the rotary selector to select
"calc'nClean"
■ Press button C The display
indicates the progress of the programme
■ Clean the beverage outlet and replace,
empty the drip trays and replace
■ Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer again
■ Remove the water filter (if there is one)
and press C
■ Pour lukewarm water into the empty
water tank up to the "05 l" mark and
then dissolve one Siemens descaling
tablet TZ80002 in it For the TZ60002 you
should always dissolve two tablets
F
If there is not enough descaling
solution in the water tank, you will
be asked to do the following. Refill
using uncarbonated water and press
C again
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container
■ Close the appliance door
■ Place a container with a capacity of
05 litre under the beverage outlet
■ Press button C The
programme will now run for about
19 minutes

Tips on energy saving

■ Remove the container and press
C
■ Rinse the water tank and (if removed)
replace the water filter.
■ Fill the tank with fresh water up to the
"max" indicator
■ Replace the water tank and close the
door
■ Place the container underneath the bev-
erage outlet again
■ Press button C The
programme will now run for about
7 minutes and rinse the appliance
■ Remove the container, empty the drip
trays, replace and close the appliance
door
■ Press C The appliance
is descaled, cleaned and ready for
use again
■ Press E to exit the program
Special rinsing
F
Important: If any of the service
programmes is ever interrupted, for
instance by a power failure, please
proceed according to the information
on the display:
■ Rinse the water tank and refill it with fresh
water up to the "max" mark
■ Press button C The
programme will now run for about
2 minutes and rinse the appliance
■ Empty the drip trays, replace and close
the appliance door The appliance is
ready for use again
■ Press E to exit the program
Tips on energy saving
■ Press button I to switch the
appliance to "energy saving mode" The
appliances uses very little power when
in "energy saving mode", but monitors all
safety-relevant functions so as to avoid
damage
■ In the menu under "Switch off after",
set the automatic switch off period to
15 minutes
en
51