Inserting/Removing An Sd Card; Vqt1D97 - Panasonic SDR-S10P Operating Instructions Manual

Inserting/removing
an SD card
Be sure to set the mode dial to OFF
before inserting/removing an SD card.
If the SD card is inserted or removed
while the power is on, this unit may
malfunction or the data recorded on
the SD card may be lost.
1
Set the mode dial to OFF.
≥ Check that the status indicator has
gone off.
2
Slide the card/battery door
lock in the direction of the
arrow and then open the card/
battery door.
≥ When the card/battery door does not
open, place your finger on the [
and open the card/battery door.
3
Insert/remove the SD card
into/from the card slot.
≥ When inserting an SD card, place the
label side A upwards and press it
straight in as far as it goes.
≥ When removing the SD card, press the
center of the SD card and then pull it
straight out.
4
Close the card/battery door
and then slide the card/battery
door lock in the direction of
the arrow.
] part
≥ If the card/battery door cannot be
completely closed, remove the card
and then insert it again.
Setup
A

VQT1D97

31