Inserting/Removing An Sd Card - Panasonic HC-W580M Operating Instructions Manual

∫ About the Speed Class ratings for recording motion pictures
Depending on [REC MODE]
Use a card that meets the following ratings of the SD Speed Class. Use of a non-compatible
card may cause recording to stop suddenly.
≥ SD Speed Class is the speed standards regarding continuous writing. To check the class, see the
labelled side, etc. of the card.
Recording formats
MP4/iFrame
AVCHD
≥ When recording with [Backup for Twin Camera]
conforming to Class 10 of the SD Speed Class Rating. If the SD Speed Class Rating is
lower than Class 10, recording may suddenly stop.

Inserting/removing an SD card

When using an SD card not from Panasonic, or one previously used on other equipment, for the
first time on this unit, format the SD card.
recorded data is deleted. Once the data is deleted, it cannot be restored.
Caution:
Check that the access lamp has gone off.
1
Open the SD card cover and insert (remove) the SD card into (from) the card
slot B.
≥ Face the terminal side C in the direction shown in the illustration and press it straight in as far as
it will go.
≥ Press the centre of the SD card and then pull it straight out.
2
Securely close the SD card cover.
≥ Securely close it until it clicks.
(l 79) and [REC FORMAT]
Recording modes
[1080/50M]
[1080/28M], [720],
[iFrame]
All
(l

(l 78), the required card differs.
Speed Class ratings
Class10
Class4 or more
(l 51) set to [ON], use an SD card
39) When the SD card is formatted, all of the


- 15 -
Label examples
Access lamp
[ACCESS] A
≥ When this unit is accessing
the SD card or built-in
memory*, the access lamp
lights up.
* only
W580M