Panasonic SDR-S10P Operating Instructions Manual page 46

Sd video camera
Hide thumbs Also See for SDR-S10P:
Table of Contents

Advertisement

Recording
Screen indications in the video recording mode
A
SP
0h00m10s
0h00m10s
0h00m10s
R 1h30m
R R 1h30m
1h30m
B
C
≥ Sound is recorded from the internal stereo microphone on the front of the unit. Take
care not to block this microphone.
≥ If the write protection switch on the SD card is set to LOCK, it cannot be used for
recording. (l 22)
≥ Each time the unit enters the recording pause mode, the counter display will be reset
to "0h00m00s".
≥ While motion picture recording is in progress, the recording will not stop even if the
LCD monitor is closed.
≥ While motion picture recording is in progress, do not disconnect the AC adaptor or
remove the battery. If you do, a repair message may be displayed when the power is
turned back on. (l 102, About recovery)
When recording stops suddenly during motion picture
recording
When using an SD card other than one that can be used for motion picture recording
(l 22), the recording may stop suddenly. At this time, the following message appears.
When motion pictures are to be recorded, use a Panasonic SD card or another SD card
which can be used to record motion pictures. (l 22)
Even if you use an SD card that can be used for motion picture recording (l 22),
this kind of message may appear.
The data on the card has been written many times and the data writing speed has
reduced. We recommend formatting the SD card being used. (l 74) When an SD card
is formatted, all the data recorded on it will be deleted so copy valuable data to a
computer prior to formatting. (l 82) (We recommend using MotionSD STUDIO etc. to
acquire data recorded on this unit. (l 82))
46
VQT1D97
A Recording mode
B Remaining time left for recording
(When the remaining time is less than 1 minute,
[R 0h00m] flashes red.)
C Recording time elapsed

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents