Precor P80 Operating And Maintaining page 101

22
3. Remove the three #10 x 1-inch self-tapping screws
4. Remove the three #10 x 1-inch self-tapping screws
5. Remove the tape holding the base unit data cable and the
6. Slide the jack panel up and out of its bracket in the right
Assembling and Maintaining RBK 800-Series Recumbent Exercise Bikes
holding the rear cover in place, then lift it off.
Figure 4: Rear cover removal
holding the left side cover in place, then pull the cover
away from the body assembly. Guide the cover around
the pedal crank, then remove it and set it aside.
Figure 5: Left side cover removal
heart rate sensor cable in place inside the upright support
channel.
side cover.