Precor P80 Operating And Maintaining page 111

32
Connecting the Television Cable
The console's television tuner is mounted inside the console's
back plate. The tuner includes a short cable adapter that
allows the television cable to be connected outside the back
plate.
To connect the television cable:
1.
2. Route the cable counterclockwise around the outside of
3. Attach the connector on the cable to the connector on the
4. Use a plastic tie to secure the connectors to the top of the
Assembling and Maintaining RBK 800-Series Recumbent Exercise Bikes
Pull the cable out through the lower right corner of the
back plate.
the back plate.
Important: In the following step, install the cable using a
torque wrench and torque not to exceed 8 lb-in. If a torque
wrench is not available, install the coaxial cable using a plain
wrench and tighten to "snug +
wrench on the internal nut to help tighten the connection.
tuner cable and tighten the two connectors securely using
two ⁷ ₁₆-inch open-end wrenches. Position both
connectors above the upper right corner of the back plate.
back plate. Pass the tie through the two small holes near
the upper right corner of the back plate, then wrap it
around the connectors and tighten it securely. Cut off and
remove the protruding end of the tie.
¹ ₄
turn." You may also use a