Precor P80 Operating And Maintaining page 102

Assembling the Exercise Bike
To install the upright support and prepare the cables for
connection to the console:
1.
2. Place the washer back onto the coaxial coupler, followed
3. Locate the tabbed end of the modular plug coupler. Snap
4. Slide the quick-disconnect terminal on the grounding lead
5. Attach the lower ends of the following cables to the inner
6. Slide the jack panel back into its bracket in the right side
7. Using a piece of tape or a plastic tie, bind together the
8. While your assistant holds the upright support in place
Remove the nut and washer from one end of the F-type
coaxial coupler packed with the P80 console. Insert that
end of the coupler through the round opening in the jack
panel.
by the nut. Use two ⁷ ₁₆-inch open-end wrenches to secure
the coupler; hold the coupler in place with one wrench
while tightening the nut with the second wrench.
this end of the coupler into the square opening in the jack
panel.
of the power cable over the grounding terminal on the
equipment frame.
side of the jack panel:
–
Ethernet cable (for P80 console)
–
Television cable (for P80 console)
–
Power cable (for P80 console)
cover.
upper ends of all cables.
over the body assembly, thread the cables upward
through the support. When you are finished, use a piece
of tape to secure the upper connectors of the cables at
the top of the support.
23