Network Connection: Windows 2000 - Fujitsu ST4120P User Manual

NETWORK CONNECTION: WINDOWS
2000
The section describes how to set the network
connection for a computer with Windows 2000.
Network Settings
In this section, you set "TCP/IP Settings," and
complete "Checking Computer Name and
Workgroup," required for the network
connection.
TCP/IP Settings
1. Click [Start] -> [Settings] -> [Control Panel].
2. Double-click the [Network and Dial-up
Connections] icon. The [Network and Dial-up
Connections] window appears.
3. Right click the [Local Area Connection], then
click [Properties] from the menu that appears.
The [Local Area Connection Properties]
window appears.
More than one network adapter is
installed in your system if more than one
[Local Area Connection] entry is
displayed. In this case, select the [Local
Area Connection] entry with [Intersil
PRISM Wireless LAN PCI Card] displayed
under [Device Name].
4. Perform the following steps.
• Click [Internet Protocol (TCP/IP)].
• Click [Properties]. The [Internet Protocol
(TCP/IP)
Properties] window appears.
5. Set an IP address as indicated in Table 3. Ask
your network administrator to check the
setting.
W i r e l e s s L A N U s e r 's G u i d e
Item
For AdHoc
Set the IP address and subnet
Network mask:
Click [Use the following IP
address], and enter a value for [IP
address] and [Subnet mask].
Select [Obtain an IP address
For
automatically]:
Infrastruc-
ture
For the DNS server, select [Obtain
Network
DNS server address
automatically].
For the IP address, DNS server,
and default gateway, follow the
network administrator's
instructions, if any.
Table 3: Setting an IP Address
6. Click [OK]. The [Local Area Connection
Properties] window appears again.
7. Click [OK]. When a message appears
prompting you to restart the computer, click
[Yes].
Checking the full computer name and
workgroup
1. Click [Start] -> [Settings] -> [Control Panel].
2. Double-click the [System] icon. [System
Properties] appears.
3. Click the [Network Identification] tab.
4. Check [Full computer name] and
[Workgroup]. Ask your network administrator
and check the setting.
Description
53