The Wireless Connection To A Network Does Not Work; The Battery Discharges Too Quickly; Smart Card Reader Is Not Recognized; Smartcard Pin Forgotten - Fujitsu Stylistic Q555 Operating Manual

The wireless connection to a network does not work

Cause
The wireless component is switched off.
The wireless component is switched on. Despite
this, the wireless connection to a network does
not work.

The battery discharges too quickly

Cause
The battery is either too hot or too cold. In this
case the battery indicator flashes.
You may have an application running that
consumes a great deal of power due to frequent
accessing of the hard disk or optical drive.
The maximum brightness may have been set
for the screen.

Smart Card reader is not recognized

Cause
Smart Card inserted incorrectly.

SmartCard PIN forgotten

Cause
PIN forgotten
Fujitsu
Troubleshooting
► Switch the wireless component on (see
"Switching the wireless components on and
off", Page 38).
► Check whether the wireless connection is
enabled by the software.
► Further information on using the wireless
component can be found in the help files.
Troubleshooting
► Bring the Tablet PC up/down to a normal
operating temperature again.
► If the operating time of the battery life is
extremely short, the battery is probably too
old. Replace the battery if necessary.
► Use the AC adapter whenever possible.
► Reduce the brightness of the screen to
lower energy consumption: You will find the
setting under Control Panel – Hardware and
Sounds – Windows Mobility Center.
Troubleshooting
► Make sure you have inserted your Smart
Card into the Smart Card reader with
the chip facing upwards / downwards
(device-dependent).
► Check whether the Smart Card you are
using is supported. Your Smart Card must
comply with the ISO standard 7816-1, -2,
-3 and -4.
Troubleshooting
► If you work in a network, contact your
system administrator, who can unlock your
Tablet PC using a supervisor PIN.
Troubleshooting and tips
73