Installing A Pen Tether; Calibrating The Pen - Fujitsu ST4120P User Manual

INSTALLING A PEN TETHER

To prevent dropping or losing your pen, you
should attach it to your system using the pen
tether. (Pen tether is not provided)
To attach the pen tether to your Tablet PC,
perform the following steps:
1. Attach the end of the pen tether with the
clasp to your pen. To do so push the end of
the tether through the hole in the pen, then
thread the opposite end of the tether through
the loop. (See Figure 2-4.)
NOTE:
The figure below may not be an exact pictorial
representation of the Pen Tether and your Pen
Tablet PC.
Pen tether
attachment
point
Figure 2-4. Installing a Pen Tether
2. Attach the other end of the pen tether to the
attachment point on your Pen Tablet PC. To do
so, insert the end of the pen tether through the
attachment point, then feed the pen through
the large loop in the tether.

CALIBRATING THE PEN

Calibration of the pen adjusts the cursor
position on the screen relative to the position of
the pen tip. You calibrate the pen to adjust the
distance error between where the pen actually
touches the screen and where the system
"thinks" the pen is touching. If the event you
wish to invoke is not displayed under the pen
tip when you use the pen, you should calibrate
the pen.
Pen calibration may be required due to the
following situations:
• The pen is being used for the first time.
U s i n g Yo u r S t y l i s t i c S T 4 1 2 0 P / 2 1 P
• The previous user of the Fujitsu Stylistic
ST4120P/21P Tablet PC writes with the
opposite hand or at a different pen angle.
• The system has been in use for some time
and the pen has not been recalibrated.
• The original system image has been
restored.
To Calibrate the Pen
1. Open the Control Panel from the Start |
Settings menu, and double-tap the Pen
Configuration icon. In the Setup Property
page, tap on [Calibrate] to start calibration.
2. Position the Fujitsu Stylistic ST4120P/21P
Tablet PC as you normally would during use.
Be sure to hold the pen at the angle that you
regulary use. Touch the screen only with the
pen tip; inadvertently touching the screen
with your finger or hand during the
calibration process, may result in faulty
calibration.
3. Perform the calibration steps according to
the instructions on the screen. The
calibration utility displays a cross-hair
symbol in the corners of the screen, one
corner at a time. Hold the pen as you
normally would while using the system and,
as accurately as possible, tap the center of
each crosshair as it is displayed.
4. When the Verify New Pen Calibration
Settings window appears, choose one of the
following steps.
• If you are satisfied that you tapped the
cross-hairs accurately, tap Yes. The taps
that you performed in step 3 are then used
to calibrate the screen.
• If you do not want to use the new
calibration, tap No.
• If you want to enter a new calibration, tap
Recalibrate. The calibration instructions
reappear.
• If you don't tap the screen within 20
seconds, the default settings will be used.
If you have successfully performed the
procedure above, the pen is now recalibrated,
and can use the system as you normally
would.
23