Initialization - Epson Photo PC-750Z Service Manual

EPSON PhotoPC-750Z

5.1.2 Initialization

This section explains initialization, which must be done before
adjustment. Unlike the previous models, even after initialization is
performed, various adjustment values are not cleared in PhotoPC-
750Z. Only the image storage area is cleared.
Perform initialization since an error may appear, if
uploading such as firmware is performed with full of
shooting data in the image area.
1. Complete the setting-up for adjustment. (See "Getting Ready for
Adjustment" on page -61)
2. Press "Initialize" button on the program. (Indication for confirmation
appears)
Figure 5-3. Screen when selecting initialization
Adjustment
3. Select "Yes" and perform initialization. A few seconds later, the
screen below will appear.
Figure 5-4. Screen after initialization is completed
Mark • to indicate the camera resolution moves about for 20
4.
seconds. (Time varies according to the image data size at that time)
Although mark • on the camera body moves slower than the timing
of the ending indication on the program, you can remove the AC
adapter or serial communication cable when you find the ending
indication on the program.
5. Press "O.K" button on the screen.
Overview
Revision A
63