Epson Photo PC-750Z Service Manual page 58

EPSON PhotoPC-750Z
SETTING THE LCD MODE SELECTION SWITCH
6. Locate the screw protrusion ("A" part in the figure) located under the
left below of the rear cabinet to the "Cover CF" inside. At this time,
leave the another screw protrusion ("B" part in the figure) out of the
"Cover CF". (When the front cabinet is installed, it will be tightened
together)
7. Tighten 2 screws (100) to the 2 holes on the rear cabinet.
8. Tighten a screw (100) to the hole located on the connector for the
serial I/F.
Figure 4-28. Installing the Rear Cabinet
Disassembly and Assembly
9. Insert the shaft into the hole on the rear cabinet and attach the cover
battery. Although the shaft is press fitted, it can be assembled
without problem by this procedure, even if the shaft is detached.
Figure 4-29. Installing the Cover Battery
10. Connect the connector (2-pin/white) on the SY1 board to the
connector on the TB2 board. Then, connect the front case and rear
case. At this time, insert the shaft, which is attached at the previous
step, to the hole of the cabinet(front) correctly. Also, since each
screw is used according to the color of the surrounding parts, follow
the surrounding color.
Overview
Revision A
58