Color Matrix Adjustment - Epson Photo PC-750Z Service Manual

EPSON PhotoPC-750Z

5.1.5 Color Matrix Adjustment

1. Complete the setting-up for adjustment. (See "Getting Ready for
Adjustment" on page -61)
2. Turn on the cooler viewer, and set the volume of the color viewer to
the maximum.
„ Perform this "Color Matrix adjustment" after
performing "AWB5100K" adjustment.
„ Leave the color viewer for 10 minutes until
brightness settles, after turning on the color viewer.
„ As it is instructed in the AWB5100 adjustment, avoid
entering any light as much as you can.
3. After turning the color viewer On, leave it for 10 minutes until the
brightness settles.
4. Set the color chart for adjustment to the color viewer.
5. Locate the camera within 18 cm from the color viewer and emit the
light to the lens.
6. Press "UV Matrix" button on the program.
Adjustment
Figure 5-7. Location of Button for Color Matrix Adjustment
7. Shooting is done automatically and 4 color matrix (UC MAT0, UV
MAT1, UV MAT2 and UV MAT3) adjustment values will appear on
the screen.
8. Press "O.K" button.
Overview
Revision A
66