Epson Photo PC-750Z Service Manual page 54

EPSON PhotoPC-750Z
9. Tighten 2 screws (102) to 2 notches located back side of the holder
LCD and one screw (102) to 1 notch at the left below on the same
holder LCD.
10. Solder the cable for prevention of radiation, which comes out of the
next to the video jack of ST1 board, to the red point shown in the
figure below.
If you can not find the gasket on the shield case of the
back side of CA1 board while the holder LCD is
installed, be sure to go to the next step (installation of
LCD monitor) after installing the new gasket.
Figure 4-20. Fixing the Holder LCD
Disassembly and Assembly
11. Install the LCD monitor by sliding it from the below to the holder
LCD.
When installing the LCD monitor to the holder LCD, it
can not be installed by pushing it from the top
forcefully. Follow the Step 11, referring to the figure
below.
Figure 4-21. Installing the LCD Monitor
Overview
Revision A
54