Baxi Arena Super Installation And Servicing Instructions page 8

INSTALLATION - Page 8
Wall Fixing
Using the closure plate supplied as a template, hold it
centrally across the fireplace opening with the bottom edge
level with the base of the fireplace opening. Mark out the six
hole positions. Remove the closure plate and drill the fixing
holes using a 6mm drill to accept the wall plugs provided.
NOTE: Where the closure plate is more than adequate
to cover the fireplace opening and to prevent the sealing
tape from becoming visible, it is advisable to trim the
closure plate (after marking the fixing holes) as follows:-
Cut 32mm (1¼in) off the top of the closure plate (i.e.
through the centre line of the top two fixing holes) and
then trim the top corners at an angle of 45° to a depth of
25mm (1in). If necessary, cut a hole in the closure plate
for the gas supply pipe.
Replace the closure plate, making sure to line it up with the
holes previously drilled and plugged and seal all edges with
a suitable tape. DO NOT COVER THE AIR RELIEF
OPENING IN ANY WAY.
If the closure plate has been cut for the gas supply pipe, seal
around this opening too.
Hold a lighted taper or match to the spigot hole in the closure
plate. If the flame is pulled into the opening, proceed with the
installation. If the flame is NOT pulled into the opening, pre-
heat the chimney for a few minutes then re-check for flue
pull. If there is no definite flow into the spigot opening, the
chimney may need attention.
DO NOT CONTINUE WITH THE INSTALLATION -SEEK
EXPERT ASSISTANCE.
Take the backing plate from the fittings pack and fix it to the
wall as shown using the 1½in wood screws provided.
Fix the two wall mounting brackets in position using the four
1½in wood screws provided.
5
Take the fire, two N° 8 x / in self tapping screws,
8
screwdriver and locate the flue spigot in the hole in the
closure plate, push the fire backwards as far as possible,
ensuring that the rear feet locate positively on the wall
mounting brackets. Whilst holding the fire in position, secure
the fire to the backing plate with the screws.
Fix the fire firmly to the wall mounting brackets as shown
5
using the two N° 8 x / in self tapping screws provided.
8
Make the gas connection to the union elbow and tighten the
flared joint.
8
Supplied By www.heating spares.co Tel. 0161 620 6677