Burners And Injectors - Baxi Arena Super Installation And Servicing Instructions

Changing Components - Page 23
Burner and Injectors
1. Ensure that the glass panel is cold.
Disengage the retaining clamps and lift the frame away.
2. Lift the coal bed away from the locating pins and place to
one side.
3. Remove the locating pins securing the burner to its
support brackets.
4. Disconnect the compression nuts from the injectors and
remove the burner, being careful not to damage the pilot
assembly.
5. Remove the injectors from the old burner and fit them into
the new burner or if required fit new injectors (flat end in the
burner) taking care not to over tighten them in their
mountings.
Re-assemble the components in the reverse order to
dismantling.
23
Supplied By www.heating spares.co Tel. 0161 620 6677