Installation - Baxi Arena Super Installation And Servicing Instructions

INSTALLATION - Page 7
Initial Preparation
To unpack the fire, remove the packing piece complete with
fitments and the pack containing the canopy and hearth
assembly. Place to one side. Remove the plastic bag and
remaining packing piece. Lift the fire from its carton.
Fitting the Fire
HEARTH MOUNTING
Take the closure plate provided and hold centrally across the
fireplace opening with the bottom edge resting on the hearth.
NOTE: Where the closure plate is more than adequate
to cover the fireplace opening and to prevent the sealing
tape from becoming visible, it is advisable to trim the
closure plate as follows:
Cut 32mm (1¼in) off the top of the closure plate (i.e.
through the centre line of the top two fixing holes) and
then trim the top corners at an angle of 45° to a depth of
25mm (1in). If necessary, cut a hole in the closure plate
for the gas supply pipe.
Seal all edges of the closure plate with a suitable tape. DO
NOT COVER THE AIR RELIEF OPENING IN ANY WAY. If
the closure plate has been cut for the gas supply pipe, seal
around this opening too.
Hold a lighted taper or match to the spigot hole in the closure
plate. If the flame is pulled into the opening, proceed with the
installation. If the flame is NOT pulled into the opening, pre-
heat the chimney for a few minutes then re-check for flue
pull. If there is still no definite flow into the spigot opening,
the chimney may need attention. DO NOT CONTINUE WITH
THE INSTALLATION - SEEK EXPERT ASSISTANCE.
Take the backing plate from the fittings pack and secure to
5
the fire using the two N° 8 x / in self tapping screws
8
provided.
Locate the flue spigot in the hole in the closure plate and
push the fire backwards as far as possible.
NOTE: A flue spigot extension may be used with this
appliance, but must not exceed 150mm (6in) when
measured from the back of the fire.
Level the fire by adjusting the front feet.
Make the gas connection to the union elbow and tighten the
flared joint.
7
Supplied By www.heating spares.co Tel. 0161 620 6677