Adjusting The Anti-Scalp Rollers; Positioning The Seat; Adjusting The Motion Control Levers - Toro TITAN ZX 5400 Operator's Manual

Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the flange nut, anti-scalp roller and bolt from
the bracket (Figure
Note: Keep the bolt and anti-scalp roller together
when removing.
1
2 3 4
Figure 25
1. Flange Nut
2. Spacer
3. Anti-scalp roller
4. Align the bolt and anti-scalp roller in the hole of the
bracket that matched the closest height of cut position
(Figure 25).
5. Insert the bolt into the bracket hole and secure the bolt
and anti-scalp roller with the flange nut

Positioning the Seat

The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
25).
5
g024312
4. Bushing
5. Bolt
(Figure
Adjusting the Motion Control
Levers
Adjusting the Height
Note: Repeat the adjustment for the opposite control lever.
The motion control levers can be adjusted higher or lower for
maximum operator comfort
A
25).
g027252
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever fore or aft. Tighten both bolts to secure the
control in the new position.
3. Repeat the adjustment for the opposite control lever.
22
Figure 26
(Figure 27).
B
Figure 27