Toro TITAN ZX 5400 Operator's Manual page 21

Using the Foot Pedal Deck Lift System
•
Press the pedal down to raise the deck; continue to press
the pedal until the deck is locked in the transport position
(Figure 23).
•
Push on the deck lift pedal with your foot and pull the
transport lock handle rearward to disengage the transport
lock (Figure 23).
Figure 23
Transport Lock Position
Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 114 mm (1-1/2
to 4-1/2 inch) in 6 mm (1/4 inch) increments by relocating
the height-of-cut pin into different hole locations.
1. Push on the deck lift pedal with your foot and raise the
mower deck to the transport lock position (also the
114 mm (4-1/2 inch) cutting height position)
24).
2. To adjust, remove the pin from the height-of-cut
bracket (Figure 24).
3. Select a hole in the height-of-cut system corresponding
to the height-of-cut desired and insert the pin
24).
4. Push on the deck lift pedal with your foot and pull
the handle rearward to disengage the transport lock
(Figure 23).
5. Lower the deck slowly until the lever makes contact
with the pin.
1. Deck lift pedal
2. Handle
g024409
(Figure
(Figure
21
2
1
Figure 24
3. Height-of-cut positions
4. Pin
3
4
g024410