Stopping The Machine; Adjusting The Height-Of-Cut - Toro TITAN ZX 5400 Operator's Manual

Driving Backward
Note: Always use caution when backing up and turning.
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion control levers
rearward (Figure 22).
Figure 21
G008953
Figure 22

Stopping the Machine

WARNING
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and move the
motion control levers outward to the park position
when leaving the machine unattended, even if just
for a few minutes.
To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the blade
control switch (PTO), and turn the ignition key to off.
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake. Remember to remove the key from
the ignition switch.
G008952

Adjusting the Height-of-Cut

The machine is equipped with a foot pedal deck lift system.
The operator can use the foot pedal to lift the deck briefly to
avoid obstacles or lock the deck in the highest height-of-cut
or transport position. The operator can use the height of
cut lever with the foot pedal to lock the deck in a specific
cutting height.
20