Toro TITAN ZX 5400 Operator's Manual page 25

3. Remove the mower as described in the Removing the
Mower procedure in the Maintenance section for more
information.
4. Turn the mower upside down.
5. Remove the existing mower blades installed on your
deck. Refer to the Removing the Blades procedure in
the Maintenance section for more information.
6. Remove the three locknuts (5/16 inch) secured to the
welded posts of the left baffle on the top of the mower
deck at the center, left of center and left positions
(Figure 33). Remove the carriage bolt and locknut on
the side wall of the mower deck securing the left baffle
to the deck.
4
3
Figure 33
1. Locknut (5/16 inch)
2. Carriage bolt (5/16 x 3/4
inch)
7. Remove the left baffle from the mower deck as shown
in Figure 33.
8. Locate the two bolts in loose parts and use the existing
locknuts. Install these fasteners into the holes shown in
Figure 33 on the mower deck to prevent flying debris.
Install the bolt up, through the underside of the deck
and use an existing locknut to secure from the topside.
WARNING
Open holes in the mower expose you and
others to thrown debris which can cause
severe injury.
• Never operate the mower without hardware
mounted in all holes in the mower housing.
• Install the hardware in the mounting holes
when you remove the mulching baffle.
9. Remove the carriage bolt (5/16 x 3/4 inch) and locknut
(5/16 inch) on the rear wall of the mower deck securing
the baffle to the deck
1
2
3. Left baffle
4. Install fasteners here
(Figure 34).
G010712
7
1
1. Carriage bolt (5/16 x 3/4
inch)
2. Locknuts, front of
discharge plate (reinstall
after baffle is removed)
3. Locknut, forward hole in
deck (reinstall after baffle
is removed)
G011149
4. Baffle guard, 54 inch
decks
10. Locate the baffle guard at the front edge of the side
discharge opening. Remove the fasteners securing the
baffle guard and the right baffle to the mower deck
as shown in
retain all fasteners.
11. Remove the two locknuts (5/16 inch) securing the
welded posts of the right baffle to the top of the mower
deck at center and right of center positions
12. Remove the carriage bolt and locknut securing the right
baffle to the top of the mower deck. Remove the right
baffle from the mower deck
25
1
6
Figure 34
5. Hex head bolt, forward
hole in deck (reinstall after
baffle is removed)
6. Carriage bolts, front of
discharge plate (reinstall
after baffle is removed)
7. Locknut (5/16 inch)
Figure 34. Remove the baffle guard and
(Figure 35).
2
3
4
5
(Figure 35).