Servicing The Fuses - Toro TITAN ZX 5400 Operator's Manual

A
C
g027672
1. Remove the wing nut and
clamp
2. Remove the negative
battery cable before the
positive
4. Remove the clamp
5. First disconnect the negative battery cable (black) from
the negative (-)(black) battery terminal
6. Slide the red terminal boot off the positive (red) battery
terminal and remove the positive (+)(red) battery cable
(Figure 53).
7. Remove the battery.
Installing the Battery
1. Position battery in the tray with the terminal posts
opposite from the fuel tank
2. First, install the positive (red) battery cable to positive
(+) battery terminal.
3. Then install the negative battery cable to the negative
(-) battery terminal.
4. Secure the cables with 2 bolts, 2 washers, and 2 locknuts
(Figure 53).
5. Slide the red terminal boot onto the positive (red)
battery post.
6. Install the clamp and secure it with the wing nut
53).
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
B
D
Figure 53
3. Remove the positive
battery cable
4. Remove battery
(Figure 53).
(Figure
(Figure 53).
Important: Always keep the battery fully charged. This
is especially important to prevent battery damage when
the temperature is below 32°F (0°C).
1. Charge battery for 10 to 15 minutes at 25 to 30 amps
or 30 minutes at 10 amps.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
3. Install the battery in the machine and connect the
battery cables, refer to Installing the Battery.
53).
1. Positive Battery Post
2. Negative Battery Post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however if a fuse blows, check the
component/circuit for a malfunction or short.
Note: The fuses are located on right hand console next to
the seat (Figure
Fuses:
•
Main, 30 amp, blade-type
•
Engine, 20 amp, blade-type
1. To replace the main fuse, grasp the fuse and pull it
straight and away from the fuse block.
(Figure
38
(Figure
Figure 54
3. Red (+) Charger Lead
4. Black (-) Charger Lead
55).
54).