Removing The Mower - Toro TITAN ZX 5400 Operator's Manual

2
1
4
1. Spring removal tool (Toro
part no. 92-5771)
2. Idler spring
3. Deck post
8. Lower the mower to the lowest height-of-cut. Place
the height-of-cut pin in the lock position for lowest
height-of-cut.
9. Remove the belt from the mower deck pulleys and
remove the existing belt.
10. Install the new belt around the mower pulleys and the
clutch pulley under the engine
WARNING
The spring is under tension when installed
and can cause personal injury.
Be careful when removing the belt.
11. Using a spring removal tool, (Toro part no. 92-5771),
install the idler spring over the deck post and placing
tension on the idler pulley and mower belt
12. Ensure that the belt is properly seated in all pulleys.
13. To install the belt covers, insert the tabs on the each
cover into the corresponding slots on the deck bracket,
ensuring that they seat. Rotate the cover to the deck
and slide the notches under the loosened bolts until
they are seated. Tighten the bolts to secure the cover
to the deck.
14. Tighten the bottom two bolts holding the mower-deck
curtain to the mower deck (
Curtain (page 32)).

Removing the Mower

Park the machine on a level surface and disengage the blade
control switch. Move the motion control levers outward to
3
G009806
Figure 74
4. Idler arm
5. Mower belt
(Figure 74).
(Figure
Releasing the Mower-Deck
the neutral position, engage parking brake, stop the engine,
remove the key, and wait for all moving parts to stop before
leaving the operating position.
Lower the mower to the lowest height-of-cut. Select one of
the following procedures depending on the mower deck size
installed to complete the removal.
Preparing to Remove the Mower Deck
1. Lower the mower to the 76 mm (3 inch) height-of-cut
position.
2. Loosen the bottom two bolts holding the mower-deck
curtain to the mower deck. Refer to
Mower-Deck Curtain (page
5
3. Remove the mower belt from the engine pulley; refer
to Replacing the Mower Belt (page
74).
47
Releasing the
32).
46).